How to Use a Pressure Washer With Hot Water

by ellison

When it comes to pressure washing, hot water is the way to go. Using hot water on a surface is more effective at loosening grease and oil. Unlike cold water, hot water is a universal solvent and will get the job done much more effectively. Listed below are some tips for using hot water. Read on to learn more. We’ll also cover how to use a pressure washer hot water.

Choose the right pump

Before choosing the right pressure washer, you’ll want to determine what type of pump you’ll need for your specific cleaning job. Direct drive pumps work best for commercial properties and smaller jobs. Belt drive pumps are stronger and can withstand tough cleaning jobs. Choose a pressure washer that has the right PSI and GPM for the job. Make sure to choose one that’s easy to transport and has the heating system you’ll need.

Oil stains are notoriously difficult to remove with cold water pressure washers. Hot water pressure washers have high enough pressure that they can remove oil and grease from surfaces faster than cold water. Oil stains are common in garages and driveways, and hot water will make the job easier. Hot water also allows you to clean the surface faster and more thoroughly. And once you’ve got those grime-filled stains out, you can proceed with the rest of your cleaning.

Use plenty of power

When using a hot water pressure washer, be sure to use plenty of power to operate the pump and change over valves. Hot water pressure washers can handle temperatures up to 140 degrees Fahrenheit, but they won’t damage your pressure washer if used in cold water. Just make sure you don’t run hot water through a cold water pressure washer. There are other ways to use hot water, but it’s always safer to use the cold version of a pressure washer when you’re not sure about the water temperature.

Before you start using a pressure washer with hot water, make sure you have water in the reservoir. The trigger gun should be locked in the “ON” position. Next, turn the gas and engine switches on. The choke lever should be in the “OFF” position, while the throttle and burner switches should be in the “ON” position. Ensure that you’re following the manufacturer’s instructions.

You can use a multi-purpose detergent for a variety of surfaces, including concrete. Concrete-specific detergents are available as well. Hot water pressure washing is also beneficial for cleaning siding because the residues left behind by previous tenants can make it look grubby. The water from a pressure washer can also get rid of mold and mildew from the siding. These substances can cause health problems if left untreated.

Adjust the cleaning process accordingly

When using a pressure washer with hot water, you must adjust your cleaning process accordingly. Hot water will provide additional pressure and heat that cold water cannot. Cold water will clean bare wood, and hot water will ruin siding. However, hot water can cause the paint to peel off and swell. Cold water pressure washers are also great for cleaning decks and siding. You can also use them to wash your vehicle.

When using a pressure washer with hot water, it will get rid of dirt much faster than a cold water machine. Hot water’s high temperature helps loosen greasy stains and will dissolve them faster than cold water. In addition, hot water will kill bacteria and germs better than cold water. So, it’s important to choose the right pressure washer according to your needs. If you’re unsure, consult your mechanic.

Cold water pressure washers are often smaller and lighter and require fewer chemical detergents. However, they require more maintenance. Cold water pressure washers are good for cleaning the simplest surfaces. They’ll do the same job as a hot water pressure washer, but they’ll cost a little more. You may prefer a cold water model for more challenging jobs. Cold water pressure washers will save you money, but they’re not as effective against grease.

Related Posts

Leave a Comment